Vectronics VC-300D Manual do Utilizador descarregar pdf (Página 4)

VC-300D Digital Bargraph Antenna Tuner Owner's Manual

REAR PANEL CONNECTORS

1. TRANSMITTER IN

Coaxial connector for input from SWL receiver or transmitter.

2. COAX 1

Coaxial connector for output to Antenna One.

3. COAX 2

Coaxial connector for output to Antenna Two.

4. BYPASS

Coaxial connector for third coax output. Bypasses tuner, but meter circuits remain

active.

5. GROUND

Post/Wing-nut type ground connector.

6. BALANCED OUTPUT

Two banana jack connectors for output to RF balanced twin-lead antennas. (Note that

jumper must be used as shown by the dotted line.)

7. END FED WIRE

Banana jack for output to a single-wire antenna. (Do not use jumper.)

8. 20V DC

Barrel connector for 15-20 VDC input, this voltage is internally regulated to 12 Volts

providing power to the digital bargraph and meter lamp. The center pin is positive (+).

1 2 3 4 5 6 7 8 9 10

Sem comentários

Vectronics VC-300D Manual do Utilizador Página 4