Vectronics VEC-1402DK Manual do Utilizador descarregar pdf (Página 8)

VEC-1402DK Instruction Manual High Performance 2 Meter Pre-Amp Kit

Transistors:

If transistors are installed incorrectly, damage may result when power is applied.

Transistors in metal cases have a small tab near the emitter lead to identify

correct positioning. Semiconductors housed in small plastic cases (TO-92) have

an easily-identified flat side to identify mounting orientation. Many specialized

diodes and low-current voltage regulators also use this type packaging. Larger

plastic transistors and voltage regulators use a case backed with a prominent

metal tab to dissipate heat (T-220). Here orientation is indicated by the

positioning of the cooling tab.

Emitter

Flat Side

Metal Tab

Metal Can Device Plastic Device Tab-cooled Device

Integrated Circuits:

Proper IC positioning is indicated by a dot or square marking located on one end

of the device. A corresponding mark will be silk-screened on the PC board and

printed on the kit's parts-placement diagram. To identify specific IC pin

numbers for testing purposes, see the diagram below. Pin numbers always start

at the keyed end of the case and progress counter-clockwise around the device,

as shown:

1 2 3 4

8 7 6 5

Installation

Key

Installation

Pin Numbers

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 22 23

Sem comentários

Vectronics VEC-1402DK Manual do Utilizador Página 8